BrugermanualLanguageFormatStørrelseDatoEnglishprp.document.label.format pdfStørrelse 39.1 KBDato 01-12-07BeskrivelseThis manual is intended for users who want to commission and maintain communication master modules on an INTERBUS system. Knowledge about the Quantum, the programming software Concept/ProWORX32 and the bus configuration tool SYC SPU LF? CD28 M (called SyCon in following texts) is required. Additionally, the reader should be familiar with INTERBUS. 33002085_K01_000_09.pdf: 156 pagesEnglishprp.document.label.format pdfStørrelse 1.9 MBDato 01-01-06BeskrivelseThis manual is designed to help the reader address I/O modules with an INTERBUS interface on the Quantum. Previous knowledge of the Quantum and Modsoft or Concept programming software is required. The reader should also be familiar with INTERBUS. This user manual applies starting with Concept version 2.5 in Microsoft Windows 98,Windows 2000 or Windows NT. NOA 611 10 works with version 3.75 of the INTERBUS Firmware (Firmware-Generation 3) and version 1.5 of the PCP channel. Additional PCP profiles such as "Drivecom" or "sensor loop" are not implemented. The INTERBUS can be configured using CMD (Configuration Monitoring and Diagnostic Software) from Phoenix Contact. Screen shots and procedures in this book refer to CMD software version 1.21. 710109_K01_000_30.pdf, 148 pages
Software - udgivetLanguageFormatStørrelseDatoEnglishprp.document.label.format zipStørrelse 42.7 KBDato 26-11-03BeskrivelseThese loadables are necessary to support INTERBUS communications with the TSX Quantum 140NOA611x0. The file includes: 1. The loadables ICNT and ICOM for INTERBUS PCP communication under Concept using the 140CPUx341x. Version is 2.08. 2. The ULEX loadable V2.09. Concept 2.2 SR2 includes ULEX V2.08Englishprp.document.label.format zipStørrelse 472.2 KBDato 26-11-03BeskrivelseThis file includes the device description for the Schneider Electric INTERBUS modules. After the installation you will have a Schneider device library in you Phoenix Contact CMD tool. This version can be used in for CMD G4 from V4.50.