Issue:
Customer wants to send a command to a PM5000 to perform remote configuration or a meter reset.

Product Line:
PM5100 (PM5110)
PM5300 (PM5330, PM5340)
PM5500 (PM5560, PM5563)

Environment:
Remote meter configuration / resets

Resolution:
The following instructions use Modbus Tester to read and write the commands. Other Modbus polling software's can also be used.

Step 1: Identify the Command Number and necessary Parameters

1. Open the Modbus Register List
2. Navigate to the Commands tab and locate the desired command
3. Write down the Command Number and the Parameters

Table 1: Modbus Register List Excerpt

Command Name	Command Number	Command Tag	Parameters
Reset All Energies	2020	C_RESET_ALL_ENERGIES	(1) Command Semaphore

Step 2: Get the Semaphore

1. In Modbus Tester, set the Data Type to "Holding Register (R03 / W16)".
2. The Command Semaphore is stored in Modbus register 5680. Therefore, set the Starting Register to 5680.
3. Set # or Registers to be 1.
4. Then Click on Read once.

5. Write down the Semaphore value

Step 3: Sending the Command

1. In Modbus Tester, set the Starting Register to 5000 and the # of Registers to 2.

2. Set register 5000 to the Command value
3. Set register 5001 to the Semaphore value
4. Set registers 5002 - 5124 to the parameter values, if used

5. Then Click "Write"

Additional Information:

What commands are available?
A full list of the commands that can be sent to the PM5000 are detailed in the Modbus Register List under the Commands tab.
The table below lists several of the most common commands:

Warm Start Reset

Set Date/Time

Reset Cycle Count

Reset All Min/Max

Reset All Demands

Reset Power Demand

Reset All Peak Demands

Reset Power Peak Demands

Reset Input Metering Peak Demand

Reset All Energies

Reset All Accumulated Energies

Reset Input Metering Accumulations

Meter Initialization

Acknowledge Alarms

Disable Alarms

Clear Data Log

Reset Diagnostic Log

What is a Semaphore and what is its purpose?
The semaphore is a number that is used to control write access to the PM5000. The semaphore can only be read once in a 4 min by a single master. Therefore, it is the only master that can send a command within the 4 min period. This process guarantees that the PM5000 is only receiving a command from one device at a time.

NOTE: The semaphore value which is received is valid for 4 minutes when not used, that is 4 minutes from the previous semaphore write.
For example: if the received semaphore value is used at the 3rd minute 30th second from when the value is received, then the same semaphore is valid for next 4 minutes.
You may use the semaphore value multiple times within that 4 minute window.
You will need to read the command semaphore again after 4 minutes from the previous read has elapsed in order to get the new number.

To download the Modbus Tester, please follow the link FA180037 .

Publicado para: Schneider Electric España