Issue:
How set Password on an ACRD200 cooling unit
Product line:
InRow ACRD200
Environment:
All Serial Numbers
Cause:
Install, Configuration
Resolution:
Press ESC until you get to the main screen (On/Standby)
Use the Up or Down arrows to find the heading Set Password
Press ENTER and select Time
Now you will be prompted for a password
Use the default password of “apc”
If this does not work check with your Admin for the correct password
If password has been lost use the last eight digits of the serial number
Press Enter again and select the Password you would like to change, either Admin or Device.
Enter new password and press ENTER.
In the next screen, select an amount of minutes for Password time out, it can be any value between 1 and 10 minutes. Once you do this, press ENTER again to accept the changes.
How set Password on an ACRD200 cooling unit
Product line:
InRow ACRD200
Environment:
All Serial Numbers
Cause:
Install, Configuration
Resolution:
Press ESC until you get to the main screen (On/Standby)
Use the Up or Down arrows to find the heading Set Password
Press ENTER and select Time
Now you will be prompted for a password
Use the default password of “apc”
If this does not work check with your Admin for the correct password
If password has been lost use the last eight digits of the serial number
Press Enter again and select the Password you would like to change, either Admin or Device.
Enter new password and press ENTER.
In the next screen, select an amount of minutes for Password time out, it can be any value between 1 and 10 minutes. Once you do this, press ENTER again to accept the changes.
Released for: Schneider Electric Ireland
