ATV12HU22M2

variable speed drive ATV12 - 2.2kW - 3hp - 200..240V - 1ph - with heat sink

Compare The maximum number of products that can be compared is 4. Remove already added products.

Main
range of product	Altivar 12
product or component type	Variable speed drive
product destination	Asynchronous motors
product specific application	Simple machine
assembly style	With heat sink
component name	ATV12
quantity per set	Set of 1
EMC filter	Integrated
built-in fan	With
network number of phases	1 phase
[Us] rated supply voltage	200...240 V - 15...10 %
motor power kW	2.2 kW
motor power hp	3 hp
communication port protocol	Modbus
line current	24 A at 200 V 20.2 A at 240 V
speed range	1…20
transient overtorque	150…170 % of nominal motor torque depending on drive rating and type of motor
asynchronous motor control profile	Sensorless flux vector control Quadratic voltage/frequency ratio Voltage/frequency ratio (V/f)
IP degree of protection	IP20 without blanking plate on upper part
noise level	45 dB

Complementary
supply frequency	50/60 Hz +/- 5 %
connector type	1 RJ45 (on front face) for Modbus
physical interface	2-wire RS 485 for Modbus
transmission frame	RTU for Modbus
transmission rate	4800 bit/s 9600 bit/s 19200 bit/s 38400 bit/s
number of addresses	1…247 for Modbus
communication service	Read holding registers (03) 29 words Write single register (06) 29 words Write multiple registers (16) 27 words Read/write multiple registers (23) 4/4 words Read device identification (43)
prospective line Isc	1 kA
continuous output current	10 A at 4 kHz
maximum transient current	15 A for 60 s
speed drive output frequency	0.5…400 Hz
nominal switching frequency	4 kHz
switching frequency	2...16 kHz adjustable 4...16 kHz with derating factor
braking torque	Up to 70 % of nominal motor torque without braking resistor
motor slip compensation	Adjustable Preset in factory
output voltage	200...240 V 3 phases
electrical connection	Terminal, clamping capacity: 5.5 mm², AWG 10 (L1, L2, L3, U, V, W, PA, PC)
tightening torque	1.2 N.m
insulation	Electrical between power and control
supply	Internal supply for reference potentiometer: 5 V DC (4.75…5.25 V), <10 mA, protection type: overload and short-circuit protection Internal supply for logic inputs: 24 V DC (20.4…28.8 V), <100 mA, protection type: overload and short-circuit protection