{}

我們的品牌

Impact-Company-Logo-English Black-01-177x54

歡迎造訪施耐德電機全球網站

歡迎訪問我們的網站
搜尋常見問題
The Ulti Switch / Dimmer is not responding to the Remote Control Unit
Possible causes are as follows

1.   Not previously programmed or improper programming. Repeat the Programming Procedures as explained in the Manual.

2.   Switch/Dimmer is set to Programme mode. The LED indicator is turned on red now, indicating the unit is in Programming mode. If programming is not required, press the Programme button to exit Programming mode.

3.   Voltage is too low. Make sure the operating voltage range is within the requirement.  220 - 240V AC 50 Hz

4.   Power rating is too low. Replace a load that meets the minimum loading requirement.



5.   RF wireless control is disabled. (Programme LED flashes continuously in the pattern of 2). Press the Programme Button of the Switch/Dimmer 6 times within 1 minute. The programme LED should stop flashing.

施耐德電機Taiwan

附件
ULTI FreeLocate Final 060316.pdf [2.22 MB]
ULTI Remote Control Final 060221.pdf [1.98 MB]
ULTI EMC Dimmer Final 060221.pdf [2.22 MB]
探索更多
系列:
可能有幫助的文章
探索更多
系列: