Browse FAQs

Why would a drive not stop when the run command is removed?

Published date: 19 June 2020

The drive does not stop, when the run command is removed.
Product Line:
Altivar 61, Altivar 71, Altivar 312, Altivar 212, Altivar12, Altivar 32
All serial numbers
The VFD is not responding to the stop command.
1).  Verify how the drive is receiving the stop command.
2).  Verify if the drive is programmed to get the stop command from that source. 
3).  Verify the drive is not in local control.
4).  Check if the run signal is jumpered/bypassed
5).  Check to see if the motor is backfeeding voltage back into the drive. 

Was this helpful?

What can we do to improve the information ?

Can't find what you are looking for?

Reach out to our customer care team to receive information on technical support, assistance for complaints and more.