Browse FAQs

Video: How to program an ATV320 for 3 wire control?

Published date: 03 June 2020

Programming an ATV320 for 3 wire control

Product Line:
Altivar 320, ATV320


Programming, setup


From main menu,
Enter on dial to go to CONF and enter.
Go down to FULL and enter.
Go down to I_0- and enter.
Set TCC for 3C for 3 wire control.  This will require the enter key(dial) to be pressed for 3 seconds.
In 3 wire control mode, DI1 is normally closed momentary stop and DI2 is normally open momentary start.
If DI1 is not made the drive will display NST.

Was this helpful?

What can we do to improve the information ?

Can't find what you are looking for?

Reach out to our customer care team to receive information on technical support, assistance for complaints and more.