How do I reset the NS-S3-1NRT (S-TAP) Sercos network switch to factory settings?
Issue:
Resetting the NS-S3-1NRT (S-TAP) Sercos network switch to factory settings.
Product Line:
PAC Drive
Resolution:
To set the network switch back to factory setting follow the instruction below:
1. Disconnect power supply from the netSWITCH SERCOS III device.
2. Push the switch to position RES (downwards) and hold it in this position.
3. Connect the 24-V power supply to the device.
4. Hold the switch for 3 seconds until the SYS LED changes to static green.
Note: The device indicates 'Reset to Factory Settings' by a flashing green SYS LED.
Released for: Schneider Electric United Arab Emirates
Need help?
Product Selector
Quickly and easily find the right products and accessories for your applications.
Get a Quote
Start your sales enquiry online and an expert will connect with you.
Where to buy?
Easily find the nearest Schneider Electric distributor in your location.
Help Centre
Find support resources for all your needs, in one place.