"Register product and see warranty terms Online" mention is displayed every time the Micrologic X control unit is energized.

The screen is displayed for the period of the control unit start up time. At the end of this period, the Home screen or any active pop-up screen is displayed.
This restart screen is displayed to invite the customer to register the MTZ circuit breaker when installed, through for example by the safe repository of Go2SE landing page.

By this way, Schneider Electric will be able to localize the equipment.

By registering, SE gives access to a web service allowing documentation linked to assets to be consulted, stored, and shared in a Schneider Electric environment.

There is no possibility to disable this message even if the registration has already been done.

Although this registration is not mandatory.

The protection is ensured as long as ready LED is blinking once per second.

In case the Micrologic unit does not have an external 24 VDC power supply and the load through the breaker is low and fluctuating, this could result in the Micrologic not receiving enough power to boot up properly, causing it to constantly reboot. In that situation, connect a laptop to the mini USB port on the Micrologic to see if the display starts up correctly. If the display starts up properly, the solution would be to provide an external 24 VDC power supply to the breaker terminals or to install the VPS module in order to prevent constant reboot.

Released for: Schneider Electric Belgium