{"searchBar":{"inputPlaceholder":"Cari berdasarkan kata kunci atau ajukan pertanyaan","searchBtn":"Cari","error":"Masukkan kata kunci pencarian"}}
{}

Selamat datang di Situs Web Schneider Electric

Selamat datang di situs web kami.
 

Pilih lokasi Anda

Welcome the the Schneider Electric French website. It looks like you are located in the United States, would you like to change your location?

Traduisez en francais
{"support":{"yesButton":"Ya","noButton":"Tidak","feedback":{"title":"Apa yang dapat kami lakukan untuk menjadi lebih baik?"},"submitButton":"Kirim","successMessage":"Terima kasih atas umpan balik Anda","title":"Apakah ini bermanfaat?","feedbackPercentLabel":"orang merasa bahwa ini bermanfaat","captcha":{"error":"Silakan centang kotak"}}}
FAQ Pencarian

Why can I not configure my KYZ output from the CM4000 display?

Issue
User cannot configure the KYZ output from the CM4000 remote display 

Product Line
Circuit Monitor 4000 Series

Environment
PowerLogic Power Metering 

Cause
Prior to firmware v10.34, the meter would not allow the user to configure the KYZ output from the remote display

Resolution
To use the remote display for KYZ configuration, upgrade the firmware on the CM4000 to a version later than v10.34. FOr instructions upgrading the firmware on a CM4000 meter, please follow the procedure listed in FA237920.