Cannot transfer the Unity application to the PLC after updating the M580 exec firmware.
Issue
Cannot transfer the Unity application to the PLC after updating the M580 exec firmware.
Product Line
M580
Product Line
Unity Pro v13.1, Windows 10 version 1902, BMEP583040 v2.70
Resolution
If you try to transfer an application to an M580 after performing an update of the exec firmware, the 'Transfer Project to PLC' selection in Unity could be greyed out and unselectable.
If you try to shutdown Unity and restart the software, it may not resolve the issue.
To resolve the issue, the PC will need to be rebooted.
This could happen if Unity has been connected to the PLC and disconnected from the PLC multiple times prior to updating the exec firmware.
Cannot transfer the Unity application to the PLC after updating the M580 exec firmware.
Product Line
M580
Product Line
Unity Pro v13.1, Windows 10 version 1902, BMEP583040 v2.70
Resolution
If you try to transfer an application to an M580 after performing an update of the exec firmware, the 'Transfer Project to PLC' selection in Unity could be greyed out and unselectable.
If you try to shutdown Unity and restart the software, it may not resolve the issue.
To resolve the issue, the PC will need to be rebooted.
This could happen if Unity has been connected to the PLC and disconnected from the PLC multiple times prior to updating the exec firmware.
게시 대상: 슈나이더 일렉트릭 Korea
도움이 필요하신가요?
제품 선택기
애플리케이션에 적합한 제품과 액세서리를 빠르고 쉽게 찾을 수 있습니다.
견적 받기
영업 관련하여 온라인으로 문의하시면 전문가가 연락드립니다.
구매처
해당 지역의 가장 가까운 슈나이더 일렉트릭 대리점을 쉽게 찾을 수 있습니다.
지원 센터
한 곳에서 모든 요구 사항에 대한 지원 리소스를 찾아보십시오.