Browse FAQs

What causes an 'OL9-1600 Not logged in to controller' error in Concept?

Published date: 26 June 2020

When a connection is attempted using Concept, the above message is returned.

Product line
Concept Programming software

This is typically a Modbus timeout error.

  • Verify that the transmit and receive buffers are set to High in the PC's COM1: port parameters.
  • Try to connect to the PLC in ASCII mode at 2400 baud rate.
  • Is the laptop running off a low battery?
  • If the PLC is a Momentum, look for a bent pin.
  • Are Allen Bradley drivers enabled?
  • It may be necessary to jumper out the handshaking (DTR/DSR) in the cable. The modified pinouts are included in the attached files.

Compact_momentum_RJ45 to DB9 To DB9

Was this helpful?

What can we do to improve the information ?

Can't find what you are looking for?

Reach out to our customer care team to receive information on technical support, assistance for complaints and more.