Geo SCADA Upgrade Issue: Wonderware Alarm Provider Service Stuck During Installation
When upgrading EcoStruxure Geo SCADA Expert, the installation process may fail because the Wonderware Alarm Provider service cannot stop. This service often gets stuck in a “Starting” state, preventing the installer from proceeding.
The installer displays the following error message:
Service 'Geo SCADA Expert Wonderware Alarm Provider' (WWAPSERVICE) could not be stopped.Verify that you have sufficient privileges to stop system services.
In Services, the Geo SCADA Expert Wonderware Alarm Provider status is stuck in Starting and does not respond to stop commands.
Step 1: Disable the Service
- Open Services.
- Locate Geo SCADA Expert Wonderware Alarm Provider.
- Right-click the service → Properties.
- Set Startup type to Disabled.
- Click Apply and OK.
Step 2: Reboot the System
Restart the computer to clear the stuck state and prevent the service from starting automatically.
Step 3: Rerun the Installer
After reboot:
- Launch the Geo SCADA installer again.
- The installation should proceed without the previous error.
Publié pour: Schneider Electric Belgium
Besoin d'aide ?
Sélectionnez le bon produit
Trouvez rapidement et facilement les produits et accessoires adaptés à vos applications.
Obtenir un devis
Effectuez une demande de renseignements en ligne et un expert vous contactera.
Où acheter ?
Trouvez facilement le distributeur Schneider Electric local le plus proche.
Centre d'aide
Trouvez des ressources de support pour tous vos besoins, en un seul endroit.