This FAQ has been written for NEAL (North East Africa and Levant) region. If you are looking for information for another region, please select the correct country from the top-left dropdown in the page and 'Navigate to Browse FAQs' in the Support menu.
PTC probes integrated in the motor to measure its temperature can be connected to the control card terminals.
This analog value is managed by the starter.
The "PTC probe thermal overshoot" value can be processed and used in two ways:
- stop in the event of a fault if the signal is active
- activate an alarm if the signal is active. This alarm can be displayed in a starter status word (serial link)
or on a configurable logic output.
Note:
PTC probe protection does not deactivate the motor thermal protection provided by the calculation. Both types
of protection can operate in parallel.
This analog value is managed by the starter.
The "PTC probe thermal overshoot" value can be processed and used in two ways:
- stop in the event of a fault if the signal is active
- activate an alarm if the signal is active. This alarm can be displayed in a starter status word (serial link)
or on a configurable logic output.
Note:
PTC probe protection does not deactivate the motor thermal protection provided by the calculation. Both types
of protection can operate in parallel.
Released for: Schneider Electric Egypt and North East Africa
