How to test the rectifier?
A bridge rectifier is composed of diodes. There are two ways to test a diode.
A. Through a Diode Test
First, make sure to disconnect the white wires and black wires from the bridge rectifier.
Then, You need to have your multi-tester dial set in Diode Test Mode. (dial setting no. 14)
B. For through Resistance Check,
You need to have your multi-tester dial set in Ohmmeter. (dial setting no. 12)
Then, check the resistance of each adjacent terminals. (top & right/ top & left/ bottom & right/ bottom & left)
You should get a resistance reading of around 97 ohms or as long as all resistance readings are approximately the same, the rectifier is good.
If unsure, contact Technical Support at 1-800-800-ASCO or send an email to technicalsupport@ascopower.com
A. Through a Diode Test
First, make sure to disconnect the white wires and black wires from the bridge rectifier.
Then, You need to have your multi-tester dial set in Diode Test Mode. (dial setting no. 14)
B. For through Resistance Check,
You need to have your multi-tester dial set in Ohmmeter. (dial setting no. 12)
Then, check the resistance of each adjacent terminals. (top & right/ top & left/ bottom & right/ bottom & left)
You should get a resistance reading of around 97 ohms or as long as all resistance readings are approximately the same, the rectifier is good.
If unsure, contact Technical Support at 1-800-800-ASCO or send an email to technicalsupport@ascopower.com
Released for: Schneider Electric Philippines
Need help?
Product Selector
Quickly and easily find the right products and accessories for your applications.
Get a Quote
Start your sales inquiry online and an expert will connect with you.
Where to buy?
Easily find the nearest Schneider Electric distributor in your location.
Help Center
Find support resources for all your needs, in one place.