X = Actual pressure being applied to transmitter

1. Press the NEXT button twice and the word CONFIG will be displayed.
2. Press ENTER and OUT DIR will be displayed
3. Press NEXT 6 times and EGU LRV will be displayed
4. Press ENTER and flashing cursor will appear at the left side of display along with a number value
5. Press ENTER and the left most digit will flash
6. Press NEXT until this digit matches the value of the most significant digit of the X value. Repeat procedure for the remaining 3 digits until the entire X value has been entered
7. Press ENTER and SET DP will be displayed
8. Press NEXT until the decimal point is in the correct location
9. Press ENTER and EGU URV will be displayed
10. Press NEXT twiceand SAVE will be displayed
11. Press ENTER and device will be returned to Measurement Display
12. Press the NEXT button and CALIB will be displayed
13. Press ENTER and display will indicate CAL AT0
14. Press next and display will indicate CAL LRV
15. Press the ENTER button and display will indicate LRVDONE
16. Press NEXT 5(five) times and SAVE will be displayed
17. Press Enter
18. Press the NEXT button twice and the word CONFIG will be displayed.
19. Press ENTER and OUT DIR will be displayed
20. Press NEXT 6 times and EGU LRV will be displayed
21. Press ENTER and flashing cursor will appear at the left side of display along with a number value
22. Press ENTER and the left most digit will flash
23. Press NEXT until this digit becomes 0 then press ENTER. Repeat procedure for the remaining 3 digits.
24. Press ENTER and SET DP will be displayed
25. Press NEXT until the decimal point is in the correct location
26. Press ENTER and EGU URV will be displayed
27. Press NEXT twiceand SAVE will be displayed
28. Press ENTER and device will be returned to Measurement Display
29. Complete

Released for: Schneider Electric Philippines