Issue
Need to configure the waveform capture on a PM800 series meter.
Product Line
PM850, PM870, ION Setup
Environment
Application using a PM800 series meter to capture waveforms
Cause
Need configure waveform capture on a existing PM850 or PM870
Resolution
Both the PM850 and PM870 can capture waveform data. Capture can be enabled in the Onboard Alarms/Event setup, see figures below.
Need to configure the waveform capture on a PM800 series meter.
Product Line
PM850, PM870, ION Setup
Environment
Application using a PM800 series meter to capture waveforms
Cause
Need configure waveform capture on a existing PM850 or PM870
Resolution
Both the PM850 and PM870 can capture waveform data. Capture can be enabled in the Onboard Alarms/Event setup, see figures below.
The PM870 can configure aspects of the waveform like the channels selected, samples per cycle, duration, and pre-event cycles. These values are fixed in the PM850. The waveform capture configuration is accessed through the Power Quality folder.
Note
- ION Setup cannot view waveforms from this device.
Gepubliceerd voor: Schneider Electric Belgium
Hulp nodig?
Selecteer zelf het juiste product
Vind snel en eenvoudig de juiste producten en toebehoren voor uw toepassingen.
Offerte aanvragen
Dien uw aanvraag online in en een expert zal contact met u opnemen.
Verkooppunten
Vind eenvoudig de dichtstbijzijnde distributeur van Schneider Electric op uw locatie.
Help Center
Vind de antwoorden die u nodig heeft via bladeren door veelgestelde vragen over onderwerpen.
