Control Expert 14 closes after DTM update hangs up.
Issue
Control Expert 14 closes after the DTM update hangs up.
Product Line
Control Expert 14.
Environment
Windows 10 Build 1803
Resolution
Control Expert 14 closes after the DTM update hangs up. This could occur on a new installation of Control Expert in a PC running
64 bit Windows 10 build 1803 with no other Schneider Electric software or third party DTM software installed.
The issue was found the be the result of a bad registry key setting for the psbroker component.
To resolve the issue, run the attached batch file.
Control Expert 14 closes after the DTM update hangs up.
Product Line
Control Expert 14.
Environment
Windows 10 Build 1803
Resolution
Control Expert 14 closes after the DTM update hangs up. This could occur on a new installation of Control Expert in a PC running
64 bit Windows 10 build 1803 with no other Schneider Electric software or third party DTM software installed.
The issue was found the be the result of a bad registry key setting for the psbroker component.
To resolve the issue, run the attached batch file.
Gepubliceerd voor: Schneider Electric Belgium
Hulp nodig?
Selecteer zelf het juiste product
Vind snel en eenvoudig de juiste producten en toebehoren voor uw toepassingen.
Offerte aanvragen
Dien uw aanvraag online in en een expert zal contact met u opnemen.
Verkooppunten
Vind eenvoudig de dichtstbijzijnde distributeur van Schneider Electric op uw locatie.
Help Center
Vind de antwoorden die u nodig heeft via bladeren door veelgestelde vragen over onderwerpen.