How to get and provide the Control-Expert’s application used by the PLC after an issue in PLC ?
1/ Open the application in Control-Expert and connect to the PLC by choosing "PLC->Connect" command or clicking on "Connect" icon
2/ Check if the opened PLC application into Control-Expert is identical to the one stored into the PLC by checking if "Equal" is set into the status bar :
If Not "EQUAL", upload the application from the PLC to the PC in Control-Expert by choosing "PLC->Transfert Project from PLC" command or clicking on "Transfert Project from PLC" icon : 
Then, check that "EQUAL" status is set into the status bar.
3/ Provide the *.sta file available in the customer folder (or archive the application file in *.sta format)
2/ Check if the opened PLC application into Control-Expert is identical to the one stored into the PLC by checking if "Equal" is set into the status bar :
Then, check that "EQUAL" status is set into the status bar.
3/ Provide the *.sta file available in the customer folder (or archive the application file in *.sta format)
Gepubliceerd voor: Schneider Electric Belgium
Hulp nodig?
Selecteer zelf het juiste product
Vind snel en eenvoudig de juiste producten en toebehoren voor uw toepassingen.
Offerte aanvragen
Dien uw aanvraag online in en een expert zal contact met u opnemen.
Verkooppunten
Vind eenvoudig de dichtstbijzijnde distributeur van Schneider Electric op uw locatie.
Help Center
Vind de antwoorden die u nodig heeft via bladeren door veelgestelde vragen over onderwerpen.