How can we see the checksum of application of M221 controller ?
For M221 controller range, it is possible to check application checksum through system words %SW94-%SW95
%SW94 -%SW95 , this is a Checksum of the application
the values of %SW94-%SW95 content can be seen/read either connected to the real M221 PLC or also in simulation mode ( the values will be the same in both case)
so for each application he can register the checksum
%SW94 -%SW95 , this is a Checksum of the application
the values of %SW94-%SW95 content can be seen/read either connected to the real M221 PLC or also in simulation mode ( the values will be the same in both case)
so for each application he can register the checksum
Udgivet til: Schneider Electric Danmark
Brug for hjælp?
Produktvælger
Find hurtigt og nemt de rette produkter og det rette tilbehør til dine anvendelser.
Få et tilbud
Start din salgsforespørgsel online, så vil du blive kontaktet af en ekspert.
Find forhandler
Find den nærmeste Schneider Electric-distributør.
Hjælpecenter
Find supportressourcer til alle dine behov på ét sted.