How to determine if the SCADAPack x70 device will require the 5103 power supply module.

• Launch the RemoteConnect software.
• Create new program by selecting the correct controller type. In our Example the SCADAPack 474 was selected.
• Under the Configuration tab>Physical IO>Local
• Start adding all the IO requirements, You'll notice that the comment below the table stating the estimate power consumption and if a 5103 power supply module is required.

• As you add more IO modules, an exclamation mark will appear on the table as a notification that it will require the 5103 power supply module.

Udgivet til: Schneider Electric Danmark