While opening wireshark for network analysis, it shows a warning 'No interfaces found', NPF driver is not running etc. and no network interfaces can be seen.
This is because the NPF driver is not running. Close wireshark and follow below steps:
-Open command prompt and 'Run as Administrator'.
-Type 'net start npf' (without inverted commas) and hit enter
-You should see the message that NPF driver has been started successfully.
-Now wireshark should run and show the list of interfaces.
-Open command prompt and 'Run as Administrator'.
-Type 'net start npf' (without inverted commas) and hit enter
-You should see the message that NPF driver has been started successfully.
-Now wireshark should run and show the list of interfaces.
Released for: Schneider Electric India
