Please, refer to this procedure to recover logs available in the redundant power supplies BMXCPS4002(S), BMXCPS3522(S), or BMXCPS4022(S). Other references have no such diagnostics available.
1 â You should have a redundant power supply connected in a redundant configuration with a power supply in master mode and the other power supply in slave mode.
2 â Install the DDT âPWS_CMD_DDTâ and âPWS_DIAG_DDTâ (if not installed) downloadable here:
https://www.se.com/us/en/download/document/CPS_RED_PREDICT_MAINT_LIB_1.06/
3 â Connect to the processor with Control-Expert
4 â Create variables to use the DDT for the âDiagnosticâ and the DDT for the âCommandâ.
7 â Attach in the case the screenshot of the animation table previously set
1 â You should have a redundant power supply connected in a redundant configuration with a power supply in master mode and the other power supply in slave mode.
2 â Install the DDT âPWS_CMD_DDTâ and âPWS_DIAG_DDTâ (if not installed) downloadable here:
https://www.se.com/us/en/download/document/CPS_RED_PREDICT_MAINT_LIB_1.06/
3 â Connect to the processor with Control-Expert
4 â Create variables to use the DDT for the âDiagnosticâ and the DDT for the âCommandâ.
- One variable for the command which is âPWS_CMD_DDTâ type
- Two variables for the two power supplies one for the master power supply and one for the slave
power supply. Both variables are typed âPWS_DIAG_DDTâ.
- Two variables for the two power supplies one for the master power supply and one for the slave
power supply. Both variables are typed âPWS_DIAG_DDTâ.
5 â Create an animation table and add the three variables within
How to create an animation table:
How to create an animation table:
ï Right click on the first variable that you want put in the animation table
ï Initialize a new animation table (if the animation table doesnât exist)
ï Initialize an animation table (if the animation table exists yet)
ï Initialize a new animation table (if the animation table doesnât exist)
ï Initialize an animation table (if the animation table exists yet)
6 â Open your animation table and parameter the two power supplies :
ï Choose the position of the Power supply: Left / Right
ï Choose the state of the Power Supply: Master / Slave
ï Check values variations
ï Choose the state of the Power Supply: Master / Slave
ï Check values variations
7 â Attach in the case the screenshot of the animation table previously set
Released for: Schneider Electric Macedonia
