{"searchBar":{"inputPlaceholder":"Search by keyword or ask a question","searchBtn":"Search","error":"Please enter a keyword to search"}}
{}

Welcome to the Schneider Electric Website

Welcome to our website.

Select your location

Welcome the the Schneider Electric French website. It looks like you are located in the United States, would you like to change your location?

Traduisez en francais
{"support":{"yesButton":"yes","noButton":"no","feedback":{"title":"What can we do to improve?"},"submitButton":"Submit","successMessage":"Thank you for your feedback","title":"Was this helpful?","feedbackPercentLabel":"of people found this helpful","captcha":{"error":"Please tick the box"}}}
Search FAQs

Video: How do you put the ATV12 drive in local mode to run off the face of the drive?

Issue:
Turn an ATV12 drive in local mode to run

Product Line:
Altivar ATV12

Environment:
All

Cause:
Requirement to operate the ATV12 in local mode using the wheel for speed control and the start stop buttons for starting and stopping.

Resolution:

Programming:
  • Hold the MOD button for 3 to 4 seconds to put this drive in local mode.
  • You will see LOC displayed followed by rdY.
  • While in Local Mode, 3 LEDs will flash top to bottom on the left side of the display to indicate Local Mode is enabled.
  • If you need to go back to remote mode hold the MOD button again for 3 to 5 seconds.
Please note: If you go between local and remote modes you will reset your logic inputs and CTL FR1 parameters to factory default.

Explore more

Can't find what you are looking for?

Reach out to our customer care team if you have any questions or need more technical support.
Explore more