Connecting an EGX150 to a serial RS485
The Serial port for the EGX150 uses an RJ45 connector, which is different from the standard RS-485 connector.
Product Line
Link150, EGX150
Environment
EGX150 serial connections
Cause
The EGX150 does not use the standard RS-485 connector.
Resolution
| Pin Number | Colour | Signal name | Description |
|---|---|---|---|
| 1 | Orange/White striped | Rx- | Receive Data - |
| 2 | Orange | Rx+ | Receive Data + |
| 3 | NC | No Connection | |
| 4 | Blue | Tx+ | Transmit Data + |
| 5 | Blue/white striped | Tx- | Transmit Data - |
| 6 | NC | No Connection | |
| 7 | NC | No connection | |
| 8 | GND | Ground |
Connect, using a straight through RJ45 cable to the RS-485 port on your EGX150.
Cut the other end (that is to be connected to your slave device) to expose the wires.
2-Wire RS-485 connection:
Use the Blue wire as the positive (+) and the Blue/White striped wire as the negative (-)
4-Wire RS-485 connection:
| RJ45 Pin Number | Master | Slave |
|---|---|---|
| 1 | Rx- | Tx- |
| 2 | Rx+ | Tx+ |
| 4 | Tx+ | Rx+ |
| 5 | Tx- | Rx- |
Kindly refer to the EGX150 User Guide for details on how to wire the RS-485 port.
Gepubliceerd voor: Schneider Electric Belgium






Hulp nodig?
Selecteer zelf het juiste product
Vind snel en eenvoudig de juiste producten en toebehoren voor uw toepassingen.
Offerte aanvragen
Dien uw aanvraag online in en een expert zal contact met u opnemen.
Verkooppunten
Vind eenvoudig de dichtstbijzijnde distributeur van Schneider Electric op uw locatie.
Help Center
Vind de antwoorden die u nodig heeft via bladeren door veelgestelde vragen over onderwerpen.