Where can I get pre and post-transfer signals on series 300 with Group G controller?
To have pre and post-transfer signals available, feature 31 needs to be enabled.
For Series 300, a set of form C contacts are provided on the group G controller as "OP1".
When the feature setting of "OP1" is set to operate the contacts as "Feature 31", the time delay settings of the pre and post-transfer signals are available.
For further information, refer to page 11 of the Group G controller user's guide. If unsure, contact Technical Support at 1-800-800-ASCO or send an email to technicalsupport@ascopower.com
For Series 300, a set of form C contacts are provided on the group G controller as "OP1".
When the feature setting of "OP1" is set to operate the contacts as "Feature 31", the time delay settings of the pre and post-transfer signals are available.
For further information, refer to page 11 of the Group G controller user's guide. If unsure, contact Technical Support at 1-800-800-ASCO or send an email to technicalsupport@ascopower.com
Released for: Schneider Electric Canada
Need help?
Product Selector
Quickly and easily find the right products and accessories for your applications.
Get a Quote
Start your sales inquiry online and en expert will connect with you.
Where to buy?
Easily find the nearest Schneider Electric distributor in your location.
Help Center
Find support resources for all your needs, in one place.