How Do I Upload or Download Parameters on an ATV320 Using the Simple Loader?

Resolution:

The Simple Loader allows you to quickly upload parameters from an ATV320 drive and download them to another drive with the same configuration.

Uploading or Downloading Parameters

• The transfer process takes approximately 34 seconds to complete.
• Press either button on the Simple Loader to start the upload or download process.
• Once the LED begins blinking, release the button and allow the process to continue uninterrupted.
• During a download to the drive, the LED may blink briefly, followed by a second blinking period lasting a few seconds. This is normal operation.
• Do not disconnect or disturb the Simple Loader until the transfer is complete.

Erasing the Simple Loader Memory

• To erase the stored configuration, press and hold both buttons simultaneously.
• Continue holding until the LED starts blinking red.
• The memory erase process completes almost immediately.

Note: Ensure the transfer process is fully complete before disconnecting the Simple Loader or removing power from the drive.

If this article does not answer your question, check out our FAQ database that has answers to more commonly asked questions:

Frequently Asked Questions - Schneider Electric (se.com)

If this FAQ did not solve your issue, you can call us at 1-888-778-2733 Option 2 and then 4 or e-mail us atdrive.products.support@se.comto create a case with our Technical Support Team.

If you are not located in North America, please contact your local Customer Care Center for assistance:

Support | Schneider Electric Global (se.com)

Released for: Schneider Electric Canada