• Set %Ir.m.c to 1: The M580 switches to Run mode (execute the program).
• Set %lr.m.c to 0: The M580 switches to Stop mode (stop program execution).
  

  NOTE: A Stop command takes priority over a Run command. A Stop command sent from a terminal or via the network has priority over the %lr.m.c input.

  An error detected on the Run/Stop input causes the M580 to switch to Stop mode.

  Do not activate this option if the associated discrete input is mapped in state RAM because this inhibits the start-up of the M580.
  

  Managing Run/Stop Remote Access

  When configuring the M580 CPU, you can help prevent remote commands/requests from accessing the CPU Run/Stop modes.
  Select the respective Run/Stop input and Run/Stop by input only check boxes according to the following table parameters to
  determine the type of remote access for your system.

Publicado para: Schneider Electric Portugal