Browse FAQs

How to perform a soft reset on an EGX100 or EGX300

Published date: 14 May 2020

A user would like to reboot an EGX100/EGX300 without removing control power or writing to registers on the gateway.

Product Line

Device Soft Reset

The EGX can be rebooted using the reset button on the front of the device.

1) On the EGX front panel, continuously hold reset button more than 10sec.

2) All of the LEDs on the EGX will flash off and then on again.
3) Once the EGX is booted back up it will have experienced a simulated power cycle. No data or device configuration will be lost.

Was this helpful?

What can we do to improve the information ?

Can't find what you are looking for?

Reach out to our customer care team to receive information on technical support, assistance for complaints and more.