Video: How does the internal barrier kit (SS20) get installed in the series F, 200 A heavy duty safety switches?

Issue:
Product Design Features

Product Line:
Heavy Duty Safety Switches

Resolution:
NOTE: The Additional barrier kit(SS20) is to be installed ONLY in the 3-Pole, 200Amp, F-Series Heavy Duty Safety Switches with 600V Arc Suppressors.
The barrier kit SS20 is ONLY designed to be used with the appropriate 3pole, 200Amp F-Series Heavy Duty Safety Switches that contain the 600V Arc suppressors.
This video is ONLY a supplement to the INSTRUCTIONS that come with the kit. PLEASE Make sure to read the instructions, along with ALL the SAFETY information BEFORE working on any electrical equipment.
Also, follow ALL the steps in the instructions.(See below attached the kit instructions)
The equipment must be installed and serviced only by qualified electrical personnel.
Make sure to turn OFF ALL Power supplying the equipment and verify the power is OFF using a properly rated voltage sensing device, BEFORE working on or with electrical equipment.



CAUTION: TURN OFF AND DISCONNECT POWER AHEAD OF SWITCH BEFORE INSTALLING BARRIER KIT.
Once all Safety steps are followed, begin the kit installation by following the steps in the instructions that come with the kit.

Released for:Schneider Electric USA