What can you do with a ATS48 soft start to limit water hammer on a pump?

Q: What can you do with a ATS48 soft start to limit water hammer on a pump?

Issue: ATS48 soft start getting water hammer on their pump. Product Line: ATS48 Environment: Water Hammer Cause: n/a Resolution: Suggest to go to the SET menu and set Sty to d (decel). Factory default is set to F (freewheel). The soft stopping by motor torque. The soft start applies torque to the motor in order to decelerate progressively on the dec ramp, avoiding a rapid stop. This type of stop reduces the risk of water hammer on a pump. Can scroll down to dec and set to around 15-20. Could increase further, if needed. Could try turning the CLP (drc menu) to off. Đã phát hành cho: Schneider Electric Việt Nam

Question

Accepted Answer

Issue:

ATS48 soft start getting water hammer on their pump.

Product Line:

ATS48

Environment:

Water Hammer

Cause:

n/a

Resolution:

Suggest to go to the SET menu and set Sty to d (decel). Factory default is set to F (freewheel). The soft stopping by motor torque. The soft start applies torque to the motor in order to decelerate progressively on the dec ramp, avoiding a rapid stop. This type of stop reduces the risk of water hammer on a pump.

Can scroll down to dec and set to around 15-20. Could increase further, if needed.

Could try turning the CLP (drc menu) to off.

What can you do with a ATS48 soft start to limit water hammer on a pump?

Đã phát hành cho: Schneider Electric Việt Nam

Sản phẩm

Hỗ trợ

Công ty

Liên kết nhanh

Đối tác

Phát triển bền vững

Sự kiện

Thông tin chuyên môn
opens new tab