IDP05S 2-Point Calibration

1. Press NEXT three times and CALIB will be displayed
2. Press ENTER and CAL ATO will be displayed
3. Press Next and CAL LRV will be displayed
4. Apply the lower range value pressure to the transmitter
5. Press ENTER and CALWAIT will be displayed
6. After 10-15 seconds, LRVdone will be displayed
7. Press NEXT and CAL URV will be displayed
8. Apply the upper range value pressure to the transmitter
9. Press ENTER and CALWAIT will be displayed
10. After 10-15 seconds, URVdone will be displayed
11. Press NEXT until SAVE is displayed
12. Press ENTER
13. Complete

Đã phát hành cho: Schneider Electric Việt Nam