Geo SCADA Upgrade Issue: Wonderware Alarm Provider Service Stuck During Installation
When upgrading EcoStruxure Geo SCADA Expert, the installation process may fail because the Wonderware Alarm Provider service cannot stop. This service often gets stuck in a “Starting” state, preventing the installer from proceeding.
The installer displays the following error message:
Service 'Geo SCADA Expert Wonderware Alarm Provider' (WWAPSERVICE) could not be stopped.Verify that you have sufficient privileges to stop system services.
In Services, the Geo SCADA Expert Wonderware Alarm Provider status is stuck in Starting and does not respond to stop commands.
Step 1: Disable the Service
- Open Services.
- Locate Geo SCADA Expert Wonderware Alarm Provider.
- Right-click the service → Properties.
- Set Startup type to Disabled.
- Click Apply and OK.
Step 2: Reboot the System
Restart the computer to clear the stuck state and prevent the service from starting automatically.
Step 3: Rerun the Installer
After reboot:
- Launch the Geo SCADA installer again.
- The installation should proceed without the previous error.
Đã phát hành cho: Schneider Electric Việt Nam
Bạn cần trợ giúp?
Công cụ chọn sản phẩm
Nhanh chóng và dễ dàng tìm được sản phẩm và phụ kiện phù hợp cho các ứng dụng của bạn.
Nhận báo giá
Bắt đầu gửi yêu cầu bán hàng trực tuyến và chuyên gia sẽ liên hệ với bạn.
Nơi mua hàng?
Dễ dàng tìm nhà phân phối Schneider Electric gần bạn nhất.
Trung tâm Hỗ trợ
Tìm sự hỗ trợ cho mọi nhu cầu của bạn tại một nơi.