How do I connect to the Edge I/O Network Interface Module via USB connection
Issue:
USB connection to the Edge I/O NIM
Product Line:
Edge I/O
Resolution:
The USB Port connection is suitable for short-duration connections for the express purposes of configuration, maintenance, and troubleshooting. It is not intended as a long-standing connection for other purposes. Further, the network interface module may only be connected to a PC.
Note: The communication cable should be connected to the PC first to help minimize the possibility of electrostatic discharge affecting the network interface module
To connect the network interface module to the PC, do the following:
You must configure a virtual Ethernet Link on your USB port, before you can access the network interface module through USB.
To configure a virtual Ethernet Link, configure an Ethernet interface of the USB-RNDIS by following the steps below:
Опубліковано для: Schneider Electric Україна
Потрібна допомога?
Почніть тут!
Знайдіть відповіді зараз. Шукайте рішення самостійно або зверніться до нашого експерта.
Звернутися до служби підтримки
Якщо вам потрібна допомога, додаткова інформація чи технічна підтримка або ви хочете подати скаргу, зв’яжіться з нашою командою з обслуговування клієнтів.
Де придбати?
Зручний пошук найближчого дистриб’ютора, магазина або спеціалізованого партнера Schneider Electric у вашому регіоні.
Переглянути відповіді на поширені запитання
Отримайте необхідну інформацію, переглянувши відповіді на поширені запитання за відповідними темами.