ATV312H075M2412

Altivar 312 Solar

Variable speed drive

Asynchronous motors

Pumping station with photovoltaic arrays

With heat sink

ATV312

0.75 kW

1 hp

200...240 V - 5...5 %

170…264 V

50...60 Hz - 5...5 %

47.5...63 Hz

Single phase

7.5 A at 240 V
8.9 A at 200 V, Isc = 1 kA

Integrated

1.8 kVA

1 kA

4.8 A at 4 kHz

7.2 A for 60 s

60 W at nominal load

0.5…500 Hz

4 kHz

2...16 kHz adjustable

1…50

150…170 % of nominal motor torque

<= 150 % during 60 s with braking resistor
100 % with braking resistor continuously
150 % without braking resistor

Factory set: energy saving mode

Frequency PI regulator

Adjustable
Automatic whatever the load
Suppressable

<= power supply voltage

Al1, Al2, Al3, AOV, AOC, R1A, R1B, R1C, R2A, R2B, LI1...LI6 terminal 2.5 mm² AWG 14
L1, L2, L3, U, V, W, PA, PB, PA/+, PC/- terminal 2.5 mm² AWG 14

Al1, Al2, Al3, AOV, AOC, R1A, R1B, R1C, R2A, R2B, LI1...LI6: 0.6 N.m
L1, L2, L3, U, V, W, PA, PB, PA/+, PC/-: 0.8 N.m

Electrical between power and control

Internal supply for logic inputs at 19...30 V, <100 A, protection type: overload and short-circuit protection
Internal supply for reference potentiometer (2.2 to 10 kOhm) at 10...10.8 V, <10 A, protection type: overload and short-circuit protection

3

AI1 configurable voltage 0...10 V, input voltage 30 V max, impedance: 30000 Ohm
AI2 configurable voltage +/- 10 V, input voltage 30 V max, impedance: 30000 Ohm
AI3 configurable current 0...20 mA, impedance: 250 Ohm

AI1, AI2, AI3: 8 ms analog
LI1...LI6: 4 ms discrete

AOV, AOC 8 ms for analog
R1A, R1B, R1C, R2A, R2B 8 ms for discrete

+/- 0.2 % for output

2

AOC configurable current: 0...20 mA, impedance: 800 Ohm, resolution: 8 bits
AOV configurable voltage: 0...10 V, impedance: 470 Ohm, resolution: 8 bits

Logic input not wired (LI1...LI4), < 13 V (state 1)
Negative logic (source) (LI1...LI6), > 19 V (state 0)
Positive logic (source) (LI1...LI6), < 5 V (state 0), > 11 V (state 1)

2

Configurable relay logic: (R1A, R1B, R1C) 1 NO + 1 NC - 100000 cycles
Configurable relay logic: (R2A, R2B) NC - 100000 cycles

R1-R2 10 mA at 5 V DC

2 A at 250 V AC on inductive load - cos phi = 0.4 - L/R = 7 ms (R1-R2)
2 A at 30 V DC on inductive load - cos phi = 0.4 - L/R = 7 ms (R1-R2)
5 A at 250 V AC on resistive load - cos phi = 1 - L/R = 0 ms (R1-R2)
5 A at 30 V DC on resistive load - cos phi = 1 - L/R = 0 ms (R1-R2)

6

(LI1...LI6) programmable at 24 V, 0…100 mA for PLC, impedance: 3500 Ohm

S, U or customized
Linear adjustable separately from 0.1 to 999.9 s

By DC injection

Input phase breaks: drive
Line supply overvoltage and undervoltage safety circuits: drive
Line supply phase loss safety function, for three phases supply: drive
Motor phase breaks: drive
Overcurrent between output phases and earth (on power up only): drive
Overheating protection: drive
Short-circuit between motor phases: drive
Thermal protection: motor

2040 V DC between earth and power terminals
2880 V AC between control and power terminals

>= 500 mOhm 500 V DC for 1 minute

1 LED (red)drive voltage:
Four 7-segment display unitsCANopen bus status:

5 ms for reference change

Analog input: 0.1...100 Hz
Display unit: 0.1 Hz

CANopen
Modbus

1 RJ45 for Modbus/CANopen

RS485 multidrop serial link

RTU

10, 20, 50, 125, 250, 500 kbps or 1 Mbps for CANopen
4800, 9600 or 19200 bps for Modbus

1…127 for CANopen
1…247 for Modbus

127 for CANopen
31 for Modbus

1.2/50 µs - 8/20 µs surge immunity test level 3 conforming to IEC 61000-4-5
Electrical fast transient/burst immunity test level 4 conforming to IEC 61000-4-4
Electrostatic discharge immunity test level 3 conforming to IEC 61000-4-2
Radiated radio-frequency electromagnetic field immunity test level 3 conforming to IEC 61000-4-3

IEC 61800-5-1

CE

145 mm

72 mm

142 mm

1.5 kg

Communication card for CANopen daisy chain
Communication card for DeviceNet
Communication card for Fipio
Communication card for Modbus TCP
Communication card for Profibus DP

IP20 without cover plate

2

TC

1 gn (f= 13…150 Hz) conforming to EN/IEC 60068-2-6
1.5 mm (f= 3…13 Hz) conforming to EN/IEC 60068-2-6

15 gn for 11 ms conforming to EN/IEC 60068-2-27

5…95 % without condensation conforming to IEC 60068-2-3
5…95 % without dripping water conforming to IEC 60068-2-3

-25…70 °C

-10…50 °C without (with protective cover on top of the drive)
-10…60 °C with derating factor (without protective cover on top of the drive)

<= 1000 m without
>= 1000 m with current derating 1 % per 100 m

Vertical +/- 10 degree

Green Premium product

REACh Declaration

Pro-active compliance (Product out of EU RoHS legal scope)
EU RoHS Declaration

Yes

Yes

China RoHS declaration

Product Environmental Profile

End of Life Information

The product must be disposed on European Union markets following specific waste collection and never end up in rubbish bins

18 months